QUICKFIT HOOD PIN KIT PART#9508
The kit installs in minutes and eliminated the need for DZUS fasteners when holding the hood in place. Mount the front hold down flap (show in picture to left) along with the four hood pins and clips and you are off to the races. Removing the hood now only takes mere second by simply popping out the 4 quick clips. Great for working in the shop, or when you need quick access under the hood in emergency situations on or off the track.
RETAIL: $60.00
BOLT ON SOLID WHEEL DISC PART#9450
Use the supplied body bolts and clip nuts to attach these to your 
standard three tab beadlock rings. This sleek design features the fully black anodized wheel disc and comes laser etched with our famous "B" logo in the middle.
RETAIL: $29.00
DRYAIR SYSTEM PART#9527
Moisture in your racing tire is your worst enemy. It causes air contamination, unwanted stagger changes and changes to your spring rate due to pressure build up. This new system uses a innovative double filtrations system consisting of an Aqua Check filter and a series of desiccant beads to essentially double dry your compressed air.
This unit is light weight, easy to transport and takes up minimal space in your race car trailer or shop.
COMPLETE AIR DRY SYSTEM: $349.00
REPLACMENT AQUA CHECK FILTER: $45.00
REPLACEMENT DESICCANT BEADS: $64.00
TIRE DEFLATOR PART#9243
Make sure all the unwanted wet air in your tires is removed
with the new tire deflator. It's comfort grip and quick connect make it comfortable and easy to use. Once the air is removed from the tires, you can now refill with dry air from your new DRYAIR System.
RETAIL: $65.00
HUMIDITY GAUGE PART#9328
After filling your tires with your DRYAIR System, clip the convenient Humidity Gauge to your valve stem and ensure your air is as dry as possible. If not, simply remove the air from your tire, and recharge with air form your AIRDRY system again. This tool allows you to easily monitor humidity levels at different stages of the evening, before and after hot laps, heat races and features.
RETAIL: $265.00
W-16 DIRTCAR ENGINE
Complete with pulleys, belts, fuel pump, distributor, wires, engine stands, lift plate, power steering 
pulley (no pump), carb spacer, Dyno tested, sealed, timing set. Shop online to see al the components and pricing for the required parts to finish your installation. Typical installation cost including motor will be less than $12000.00. Bicknell Racing Products offers evert part to do a complete install!
RETAIL: $9950.00 plus $250.00 shipping = $10200.00
To order any of the parts listed above call our parts sales lines
Canada: 905-685-7332
US: 716-285-7502
shop online @ www.bicknellracingproducts.com